Leica M-P (Typ 240) Betriebsanleitung Seite 173

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 261
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 172
EN
169
Basic picture settings
Note:
By factory default, the
Maximum ISO function is limited to ISO 800.
To restrict the automatic setting range
4. In this sub-menu, select
Maximum AUTO ISO and/or Maximum
exposure time..
5. In the
Maximum AUTO ISO sub-menu, select the highest
sensitivity to be used, and thus the range within which the
automatic setting will operate, or in the
Set maximum
exposure time sub-menu select either one of the focal
length-specific settings - 1/focal length, 1/[2xfocal length], 1/
[4xfocal length]
2
if you want to leave it up to the camera to
ensure blur-free shutter speeds, or select the slowest shutter
speed you want to specify (1/2s - 1/500s, in whole steps). In
the focal length-specific settings, the camera only switches to
a higher sensitivity if the shutter speed would fall below the
threshold due to lower brightness, e.g. with a 50mm lens at
slower speeds than 1/60s at 1/focal length, or 1/125s at 1/
[2xfocal length], or 1/250s at 1/[4xfocal length].
6. confirm your setting with the
INFO (32) or SET button (21).
Specifying AUTO ISO mode in manual exposure setting
4. In this sub-menu select
AUTO ISO in M mode, and then On or
Previous ISO.
5. If you select
On, automatic control is active (where appropriate
within the limit you specified in the
Maximum AUTO ISO
sub-menu item). If you select Previous ISO., the last manually
set sensitivity will be used.
6. confirm your setting with the
INFO (32) or SET button (21).
Note:
The following rule applies when using automatic bracketing (see p.
188):
The sensitivity automatically determined by the camera for the
uncorrected picture is also used for all other pictures in a series,
i.e. this ISO value is not changed during a series. This may mean
that the slowest shutter speed specified under
Set maximum
exposure time is exceeded.
2
This function requires the use of coded lenses or setting of the lens type used in
the menu (see p. 163).
Seitenansicht 172
1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 260 261

Kommentare zu diesen Handbüchern

Keine Kommentare