Leica M Monochrom Bedienerhandbuch PDF herunterladen (Seite 104)

102

INSERTING / REMOVING THE BATTERY TO /

FROM THE CAMERA

1. Set the main switch (1.19) to

OFF

2. Remove the bottom cover (1.35) of the camera.

To do this:

a. Flip up the toggle (1.36) in the bottom cover,

b. Turn it to the left, and

c. Lift off the bottom cover.

3. Insert the battery into the compartment with

its contacts facing forwards. Press it into the

compartment (1.37) until the white sprung locking

catch (1.38) moves over the battery to hold it in

place.

4. Replace the bottom cover. To do this:

a. Insert it into the retaining clip (1.9) on the side of

the camera

b. Swing it down,

c. Lock it by turning the toggle to the right as far as

the stop, and

d. Push the toggle back down.

To remove the battery, follow these instructions in

reverse order. The white sprung locking catch in the

battery compartment must be pushed to the side to

release the battery.

Note:

Always turn the camera off before removing the battery.

A fully charged battery (to CIPA standards) is sufficient

for approx. 350 pictures each reviewed for 4s.

CHARGE LEVEL DISPLAYS (3.1.1)

In picture mode, the battery charge level is displayed

on the monitor (1.32) by pressing the

INFO button

(1.22). If the capacity is below 10%, the battery must be

replaced or recharged.

Notes:

• Remove the battery if you will not be using the

camera for a long period of time. When doing so, turn

the camera off using the main switch first.

• After 3 months out of use, the back-up battery in

the camera will be exhausted (see also the last

note under “Charging the battery”, p. 100), and all

individual settings will need to be made again.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 169 170

Kommentare zu diesen Handbüchern

Keine Kommentare

Leica M Monochrom Bedienerhandbuch Seite 104

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kamera Blitze Leica M Monochrom